1. Serial Terminal For Linux

The terminal itself has two ports on the back, one marked MODEM and one marked AUX. From the manual, normally the device you're connecting to uses the MODEM port, and another ancilliary device like a printer uses the AUX port. These are both DB25 ports. Jun 23, 2017  Setting up a Serial Terminal with Mac. OS X. You have now established a serial communication with your board. You can interact with your board by entering common Linux commands. For a summary of useful commands, see Common commands for the Intel® Edison board. Apr 27, 2013  Hi, Can anyone point me in the right direction for how to connect to my Catalyst Switch over console using OSX terminal. I've got my blue DB9 - RJ45, bought a USB - DB9, ensured the driver was installed and followed various peoples advice and have had no results what so ever.

Requirements

You have assembled your Arduino* expansion board or your mini breakout expansion board, installed the appropriate drivers, and flashed the OS image (formerly called firmware).

Labview serial terminal vi. This input accepts the following values.0no parity (default)1odd parity2even parity3mark parity4space parityerror in describes error conditions that occur before this node runs. This input accepts the following values.0None (default)—The transfer mechanism does not use flow control. This input accepts the following values.101 stop bit151.5 stop bits202 stop bitsflow control sets the type of control used by the transfer mechanism. This input provides functionality.stop bits specifies the number of stop bits used to indicate the end of a frame.

Steps to Set Up a Serial Terminal

1. Launch Spotlight by pressing Cmd + Space.
2. Type terminal.
3. Select the Terminal app.
4. In the Terminal window, enter the command:

   ls /dev/cu.usbserial-*

5. In the list of connected devices, look for a device that contains cu.usbserial. In the example above, the device name is /dev/cu.usbserial-A402YSYU.
   

   Note: If your device is not in the list, verify that your board is powered on and connected to your system. Select the appropriate link below: Assembling the Intel® Edison board with the Intel® Edison mini breakout board

6. Connect to the USB serial device using the Terminal screen utility by entering the command:

   screen /dev/xx.usbserial-XXXXXXXX 115200 –L

   where /dev/xx.usbserial-XXXXXXXX is replaced by your device unique name. Using the example above, the command would be:

   screen -L /dev/cu.usbserial-A402YSYU 115200 –L

   Note: Adding –L to the command, as shown above, turns on output logging so you can see the results of your commands. To end a session in Screen type Ctrl + A and then Ctrl + K to kill the session. You will be prompted to end the session.

7. At the blank screen, press Enter twice. A login screen is displayed.
8. At the login prompt, type root and press Enter.
9. Press Enter when prompted for a password. The following screen is displayed:

   
   You have now established a serial communication with your board. You can interact with your board by entering common Linux commands. For a summary of useful commands, see Common commands for the Intel® Edison board.

Serial Terminal For Linux